Propex Heatsource 2800 high output blown air heater frequently asked questions.
Q. Can the heater be mounted vertically?
A. The heater must not be mounted vertically on its nose or end or upside down but on one of its sides is not a problem. Remember when mounting the unit you should ensure you can still maintain access to the electronics cover and gas connections
Q. Where can the heater be fitted?
A. Most installations are mounted in a bedbox or locker. External installation is not recommended unless using the appropriate mounting box. However the HS2211 is designed to be fitted externally.
Q. How noisy is the heater?
A. There is very little burner noise from the heater itself. However, there will be some noise from the blown hot air similar to that of a small domestic fan heater.
Q. Can the heaters be used while vehicles are moving?
A. Yes, a vehicle in motion flue terminal is available and the heater should be installed and operated in compliance with the relevant regulatory requirements. Use of the the correct VIM bracket ensure compliance with the vehicle in motion test regime.
Q. What length of exhaust flue pipe can be fitted?
A. Total combined length must not exceed 4 meters and the inlet pipe should be slightly longer than the exhaust to balance the burner.
Q. What is the electrical consumption?
A. 1.6amps on 12v
Q. How much do they cost?
A. From as little as £496 for a Heatsource 2000 complete with a single outlet vehicle fitting kit and thermostat.
